Series Land Rover parts for sale

[mepham55]

Looking to clear out some more parts from the stash. Let me know if you see anything in the pictures you could use.

Matt

[Canadman]

I can use the exhaust manifold Matt.

[Canadman]

Actually intake manifold and oil spout too.

[mepham55]

Actually intake manifold and oil spout too.

I’ll put them aside for you.

Matt

[mikecal]

Hi Matt, I am looking for the air intake elbow between the carb and flex hose for a 1972 series III petrol. I think there is one in one of the pictures. Look forward to hearing from you. Mike

[Canadman]

Hey Matt, I dont mind paying shipping if you want to get me a price. I can etransfer you.

[mepham55]

Hey Matt, I dont mind paying shipping if you want to get me a price. I can etransfer you.

Will do. I’ll pm you prices and a shipping quote

[Canadman]

Thank you sir. :)

[Canadman]

Basically, other than the starter, I need anything that attaches to the engine minus block and valve cover, lol.

[Landydoni]

Ill take a valve cover, intake and intake elbow please!

[Canadman]

Hey Matt, did you ever sort out shipping cost for those parts I was wanting? Let me know and I'll etransfer you.

[rovermike]

Hi Matt,would you have 2 rear corner glass for 88 hardtop?If so hopefully not too scratched.Also looking for Zenith carb intake elbow & fuel filler bracket.(pce that rivets to body)

[mepham55]

Hi Matt,would you have 2 rear corner glass for 88 hardtop?If so hopefully not too scratched.Also looking for Zenith carb intake elbow & fuel filler bracket.(pce that rivets to body)

Yes I have all these parts. What hard top do you have regular or tropical top?

Matt

[rovermike]

It's a regular top from 1973.The glass is held in with brackets,not the type with seal that you rope in.Since you have all that,do you have a core solex carb with intact heater element.Even if throttle shaft is worn.I have a good one but missing pcs.It's from a 65 2a.

[mepham55]

It's a regular top from 1973.The glass is held in with brackets,not the type with seal that you rope in.Since you have all that,do you have a core solex carb with intact heater element.Even if throttle shaft is worn.I have a good one but missing pcs.It's from a 65 2a.

I’ll check on the rear glass.
For the Solex. Finding a working heater element is hard or do you just want the parts so you can assemble the carb. I have lots of Solex parts but all of the heater units have had the spade connector ripped out of them.

Matt

[RobinS]

Hi Matt, do you have any series one solex carbs where the throttle shaft and body is in good condition? Regards Robin

[mepham55]

Hi Matt, do you have any series one solex carbs where the throttle shaft and body is in good condition? Regards Robin

Hi Robin, I do not have many parts for the series 1 Solex but I do have the tools to rebush the carbs(this is what I did on my series 1 & 2) Solex.

Matt

[rovermike]

Hi Matt,if you don't have a intact heater element all I would need is the fuel pump injector pt# 503905 & the 4 screws that hold starter/heat element to body of carb.
I'll pm you.Mike.

[RobinS]

thanks Matt , I will give you a call

[rovermike]

Matt,
Tried to pm you but no response?Maybe you could try from your end
Mike.