For sale 70's mustang engine runs but needs O/H probly.
Adaptor bell housing for series 1, 2, or 3 gearbox, was installed in a safari, lve message 2502495358
For sale, early mustang v8 engine was installed in a safari has bell housing adaptor plate for S1, 2, or 3 gearbox eng.
Forum rules
Private Sales Only. Vendors/Dealers, pls use Vendors section. Sellers - pls mark post "SOLD" when your items sell.
By posting in this forum, you agree not to post anything abusive, obscene, vulgar, slanderous, hateful or threatening, Doing so may lead to you being immediately and permanently banned.
Private Sales Only. Vendors/Dealers, pls use Vendors section. Sellers - pls mark post "SOLD" when your items sell.
By posting in this forum, you agree not to post anything abusive, obscene, vulgar, slanderous, hateful or threatening, Doing so may lead to you being immediately and permanently banned.
-
Quesnel44
- Grease Monkey
- Posts: 7
- Joined: Sat Aug 22, 2020 3:29 pm
For sale, early mustang v8 engine was installed in a safari has bell housing adaptor plate for S1, 2, or 3 gearbox eng.
- Attachments
-
- 20230923_144110.jpg
- (73.24 KiB) Downloaded 80 times
-
ryancr500
- Tomb Raider
- Posts: 365
- Joined: Mon Oct 09, 2017 9:21 am
Re: For sale, early mustang v8 engine was installed in a safari has bell housing adaptor plate for S1, 2, or 3 gearbox
Did the motor use the existing motor mount locations?
-
jacobko
- Crank Case
- Posts: 126
- Joined: Mon Mar 19, 2018 12:09 pm
Re: For sale, early mustang v8 engine was installed in a safari has bell housing adaptor plate for S1, 2, or 3 gearbox
This looks like it would only work for a series 2 (non-2.0L) and 2a gearbox. The series 1 has a different bolt pattern on the bellhousing. and the series 3 slave cylinder would interfere with the v8 engine block.
-
gooffer
- Junior Craftsman
- Posts: 20
- Joined: Thu Oct 31, 2019 10:55 am
Re: For sale, early mustang v8 engine was installed in a safari has bell housing adaptor plate for S1, 2, or 3 gearbox
kiss your gearbox goodbye with this setup. Not even going to talk about half shafts...