As some of you may know from the last club meet at Triangle road, my 90 has attempted to become a steam engine.
I have been getting quotes from machine shops to skim my 200tdi head and re-condition the valves. I don't have much to go on as far as reputations. All I have are quotes from a few shops.
Are there any machine shops club members can recommend between White Rock and UBC? (or anywhere not too far off that route)
Thanks,
David
Machine Shops
-
DBrands
- Wing Nut
- Posts: 151
- Joined: Mon Feb 18, 2008 4:37 pm
- Location: Edmonton, AB
-
BOlson
- Three Wheeler
- Posts: 100
- Joined: Sun Jan 10, 2010 12:59 pm
- Location: richmond
Re: Machine Shops
A very good Engine machine shop I can recommend is Magnem Engines in Burnaby ( on Boundary between 1st ave and Hastings ) Talk to Randy....... great place for parts too
-
kRiS
Re: Machine Shops
I had quite a bit of work done by
Pacific Parts Machine Shop in Vancouver
604.874.6313
If I recall the guy running the shop is Peter.
They do a lot of work on Diesel engines, big and small.
I did try magnem engine services but found them
to be very disorganized and know very little when it comes to Diesel engines .
Kris
Pacific Parts Machine Shop in Vancouver
604.874.6313
If I recall the guy running the shop is Peter.
They do a lot of work on Diesel engines, big and small.
I did try magnem engine services but found them
to be very disorganized and know very little when it comes to Diesel engines .
Kris