The Rover-Landers of BC

Hi All,

I'm in the process of putting new front brake cylinders on my 83 109. I have replaced many a shoe in my time, but for the life of me cannot figure out how to get the springs set. They are new.

Do I position the shoe, then set the spring (tuff because it's behind the hub and I don't have alot of room to use a screwdriver to pry them back in) or do I set the spring and then force the shoe into place. Should I start with the top in place or the bottom.

THis is the model with two cylinders per side...top and bottom.

Any and all help appreciated.

:wink: I've always taken the time to pull the hub. Makes it a lot easier and and less frustrating. All the best
Regards, Derek
'82 Airportablelightweight
'89 Land Rover 110 8)

I've got freewheeling front hubs.

How much of a job is it to take them off as opposed to regular standard hubs?

Hi DAve,

I hope you didn't pull the hubs just to get the shoes on.

It's a snap to do with the right technic. But I think it too difficult to explain. Give me a call tomorrow.

Later,
Don
604-985-6317

Nope gave up for the night...too dark and brrrrrr cold.

I'll ring you tomorrow...check your rovertech email for a little surprise.

Dave