Page 1 of 1
De Fenders
Posted: Thu Sep 06, 2007 9:37 am
by dan
Hi all, I am putting the wings back together on my 110, and would like to know if I need to put any kind of stripping or whatever else where the wing parts are bolted together.
Is body tape related to this?
Thanks for all your help. Dan.
Posted: Thu Sep 06, 2007 11:38 am
by Bill E.
Hi Dan,
The factory doesn't put anything at any of the joints in the wings. I haven't noticed any corrosion at the interface between the wing and the steel bulkhead but I suppose if there are going to be problems this is where they would appear first. Perhaps an insulating strip in this joint could be useful. I wouldn't bother with any of the other joints. IMHO
:spinning:
Posted: Thu Sep 06, 2007 3:41 pm
by JD
One could put a llittle roofing zinc strip in between the joints. The zinc will corrode before the iron whether stainless or galvanized.
JD
Joint
Posted: Thu Sep 06, 2007 10:02 pm
by rick.m
Body panel ADHESIVE comes in rolls from places like NAPA or our LORD CO stores. it is used in airstream trailers and other places, easy to use too. . all the best rick.m