The Rover-Landers of BC

I'm putting all new bushings in the front of my LR3, and am a bit baffled at the current point.

Lower control arm rear bushings are directional. The manual says "Make sure the bushing is aligned correctly." but doesn't say how to align it or provide a picture to show the alignment.

Any thoughts?

Jake,

Check out:

https://www.youtube.com/watch?v=zTzKf8yMwsU

Thanks Martin,

I did find a few pictures. If anyone is looking this up later, the cutouts on the bushing go up and down if the a arm is sitting flat.