The Rover-Landers of BC

Hello all,
On my Disco 1 after unlocking all the doors, door lock plungers pop up normally, but on the rear driver side when I go to unlatch the door the plunger pops down thereby the door won’t unlatch to open. I have to pull the plunger up fully to open and stays that way until the next lock/ unlock cycle. On the tailgate the plunger pops up but pops down (mechanical) when trying to unlatch the door. I have to insert my key and hold the lock in the unlock position in order to open the tailgate each time.

Is this situation a latch adjustment or latch spring replacement?
Thanks

It is a small little circular spring. I have a few extras in east van if you need.

landcrabmechanic wrote:It is a small little circular spring. I have a few extras in east van if you need.

I do need them then. I’m in Vancouver near city hall. I could pick them up from you. Price? PM me for contact info.


Sent from my iPhone using Tapatalk

Amadreas wrote:

landcrabmechanic wrote:It is a small little circular spring. I have a few extras in east van if you need.

I do need them then. I’m in Vancouver near city hall. I could pick them up from you. Price? PM me for contact info.


Sent from my iPhone using Tapatalk

Sorry I jumped the gun and PM you my contact details.


Sent from my iPhone using Tapatalk

Received some new latch springs. Will start the arduous process of replacing the springs. Thanks again.


Sent from my iPhone using Tapatalk

Amadreas wrote:Received some new latch springs. Will start the arduous process of replacing the springs. Thanks again.


Sent from my iPhone using Tapatalk

Would you mind documenting the process with photos?


Sent from my iPhone using Tapatalk

I will fully document the procedure once I get time to. Still working as I’m considered an essential employee.


Sent from my iPhone using Tapatalk