Page 1 of 1
Series 3 lower dash
Posted: Tue May 07, 2019 9:54 am
by jpclinging
Hi all,
looking for yet another part...just pulled off my lower dash and it pretty much fell apart in my hand it was so rusty on the bottom. So I'm in real need a rust free series 3 lower. Any help would be appreciated!!!
Re: Series 3 lower dash
Posted: Sat Jul 06, 2019 8:00 pm
by tony
I have a lower dash if still needed.
Re: Series 3 lower dash
Posted: Wed Jul 10, 2019 8:33 pm
by jpclinging
Great, do you have any pics? What is the condition?
Re: Series 3 lower dash
Posted: Wed Jul 10, 2019 8:55 pm
by tony
I took it off a truck 25 years ago, haven't seen it in quite some time but it was in good shape as far as i remember. Ill have to go get it from my sisters place before i can send you a picture.
Re: Series 3 lower dash
Posted: Mon Jul 15, 2019 1:33 pm
by jpclinging
Thanks Tony!
Re: Series 3 lower dash
Posted: Mon Jul 15, 2019 9:18 pm
by tony
OK, not as great as i remembered, the steel is fine but it did have an electric brake controller attached to it so there are some holes drilled into it but nothing that could not be fixed. I had a new sheet of vinyl contact cemented to my lower 110 dash which could also be done to this one to clean it up. I don't have a photo bucket account to upload pictures so PM me and i will send you some.
Re: Series 3 lower dash
Posted: Sun Aug 04, 2019 10:29 am
by jpclinging
Hi Tony, I PM'd you my email some time ago, did you get it?
Re: Series 3 lower dash
Posted: Sun Aug 04, 2019 8:54 pm
by bsa_m21
You can attach them to these posts from your pc/Mac/iPad/android. Select the attachments tab in the full reply editor, select the photo and upload, then select “place inline”. Voila. Done.
M.
Re: Series 3 lower dash
Posted: Mon Aug 05, 2019 4:51 pm
by jpclinging
tony wrote: Sat Jul 06, 2019 8:00 pm
I have a lower dash if still needed.
Tony, can't seem to send a PM, my email is
[email protected]
Cheers.