The Rover-Landers of BC

SOLD.

My father came home with a 73 Land Rover Series 3 88" as a project to work on. The frame it too far gone and leaf springs and brake lines are shot. The rover is complete other than that. Has a gas 2.25 motor which turns over but isn't running. Bulkhead is in good shape with some small sections of minor rust. Let me know if anyone needs anything. You can email me at [email protected] for any other inquiries.

Hi
Is that the red one?
Ty
Marc

Was Red/Blue
now mostly Zinc Chromate primer yellow :)

It was originally blue!
All parts available.
Front axle drum to drum $200
Rear axle drum to drum $200
SOLD Rear tub $300
SOLD Hard top with headliner $300
SOLD bulkhead, doors, windshield, fenders, hood
4 wheels (bad tires) but rims great $150
Engine $500
Transmission $500
Transaxle $200
Or take complete, still attached motor,tranny, transaxle, package for $1000

PM sent.

Can anyone tell me if there is any fitment differences between the Series 3 and 2A axles?
I'm actually thinking about putting them on a Series 1. I've used 2A axles before without too much problem, but just wondering if there is anything different on these.

Any info would be appreciated.

I'm in need of dash pieces. What's the condition like of top and bottom dash pieces and end caps?

Matthew
1973 SerIII 88"

I sold everything