Page 1 of 1
Warn locking hubs
Posted: Tue Feb 05, 2019 1:59 pm
by dixono
Do warn locking hubs from a 2a fit on a series 3?
Re: Warn locking hubs
Posted: Tue Feb 05, 2019 4:23 pm
by mepham55
Usually no. series 3 trucks have 24 spline axle shafts and 2a trucks had 10 spline axles. Although, someone could have swapped your axle at some point. Just take the hub cap off the front axle and see how many splines they have.
Matt
Re: Warn locking hubs
Posted: Tue Feb 05, 2019 4:55 pm
by dixono
I got yah. I’ll check. Thank you for the info
Is it just me or are the stock ones junk?
Re: Warn locking hubs
Posted: Tue Feb 05, 2019 5:16 pm
by mepham55
Technically there are no “stock” free wheel hubs. These would have been fitted by the dealer or owner not by Land Rover. The only Land Rover approved free wheel hubs were made by MAP.
Matt
Re: Warn locking hubs
Posted: Wed Feb 06, 2019 12:18 pm
by TimberPig
mepham55 wrote: Tue Feb 05, 2019 4:23 pm
Usually no. series 3 trucks have 24 spline axle shafts and 2a trucks had 10 spline axles. Although, someone could have swapped your axle at some point. Just take the hub cap off the front axle and see how many splines they have.
Matt
Aren't the earlier S3's still 10 spline at the hubs? I thought it was only '80 on S3's that used 24 splines at the hubs?
Re: Warn locking hubs
Posted: Wed Feb 06, 2019 7:54 pm
by Rambler
I believe so yes. My 1974 Series 3, 2.25 petrol 88, had the 10 spline shafts front and rear and warn M11 free wheel hubs at front.
Re: Warn locking hubs
Posted: Sat Feb 22, 2020 1:17 pm
by wrongway
I have a set of 24 spline locking hubs for sale if anyone needs a set.