Poor Running Series IIa

Message
Author
tony
Little Wheel
Posts: 83
Joined: Sun Mar 04, 2007 3:33 pm
Location: Fraser Valley
Contact:

#1 Post by tony » Mon Oct 08, 2007 11:28 pm

Check your carbs internal seals , especialy the rubber parts , I have seen those deteriorate when a carb has been sitting far too long without gas in it , they tend to dry out .

harv
Maxi Drive
Posts: 310
Joined: Mon Oct 22, 2007 9:49 am
Location: Kelowna, BC

Re: Poor Running Series IIa

#2 Post by harv » Mon Oct 22, 2007 10:57 am

suede wrote:Series IIa, 88inch, 1964, 2.25 petrol, 36K miles. My rover had been sitting for at least 12 years. I got it running this year (nothing done to the engine). The first 200-300 miles it seemed to run good. Then it started losing power intermittently (every 10-15 seconds). At slow speeds it felt like it was lurching-high speeds the momentum eased this feeling. During this time it never died. I turned the mixture screw on the carb and it started running better (w/o the power loss). Consequently it was smoking pretty bad (it would gag me at a stop light) and smelling pungantly like fuel. The other day after driving 20 miles it wouldn't start. It sat hours then started again. A complete tune-up will come paycheck to paycheck. Any ideas on where to start? Thanks
I had a similar problem on my IIA. It had sat for 18 yrs. I removed the plug at the bottom of the fuel tank, and the fuel outlet port & sender from the top, and blasted all the crap (lots of it) out of the tank with a garden hose and spray nozzle. I've been driving it another 12 yrs without another similar problem. This might be worth a try on yours. Harv

tony
Little Wheel
Posts: 83
Joined: Sun Mar 04, 2007 3:33 pm
Location: Fraser Valley
Contact:

So what was it?

#3 Post by tony » Fri Nov 23, 2007 7:09 pm

What did it turn out to be ?

Post Reply