Blower fan in 88 works until engine is started

Message
Author
davran

Blower fan in 88 works until engine is started

#1 Post by davran » Sun May 03, 2015 2:17 pm

Riddle me this. The blower fan in my 88 works fine on both speeds until I start the engine: then it stops blowing air: sometimes. Turn off engine and fan works again.

???

Thanks,

davran

Re: Blower fan in 88 works until engine is started

#2 Post by davran » Sun May 03, 2015 2:54 pm

To be clear, the fan doesn't blow air when the key is in the off position. It does blow whe key is on, or on accessory, and usually stops blowing when engine is started.

Greg S
Spanner Man
Posts: 844
Joined: Sat Feb 28, 2004 9:00 pm
Location: Duncan
Contact:

Re: Blower fan in 88 works until engine is started

#3 Post by Greg S » Sun May 03, 2015 3:30 pm

Is it somehow connected to the earth of your "IGN" warning light? I'd suggest tracing the source power for the fan, make sure it agrees with the wiring diagram, then the earth wires.

LR01011000
Junior Craftsman
Posts: 28
Joined: Thu Oct 09, 2014 4:26 pm
Location: West Kelowna, BC

Re: Blower fan in 88 works until engine is started

#4 Post by LR01011000 » Mon May 04, 2015 12:28 pm

Sounds like symptoms of a bad ground....easiest test would be to run a temporary ground wire direct from the fan to the battery negative....

davran

Re: Blower fan in 88 works until engine is started

#5 Post by davran » Mon May 04, 2015 12:47 pm

Shall try all suggestions.

davran

Re: Blower fan in 88 works until engine is started

#6 Post by davran » Mon May 04, 2015 7:10 pm

The problem with Roddy's heater fan is the ignition switch; when I start the engine and the fan quits, if I turn the key back a bit towards 'off' -- but keep the engine running -- the fan starts. The 'fix' is repeatable.

WD40 has made the problem almost non-existent; my Mother, a devotee of the spray, would be so happy...

Post Reply